Snmp Configuration Example - HP V1910 User Manual

Item
UDP Port
Security Model
Security Level
Return to SNMPv1 or SNMPv2c configuration task list

SNMP configuration example

Network requirements
As shown in a, the NMS connects to the agent, Switch, through an Ethernet.

The IP address of the NMS is 1.1.1.2/24.

The IP address of the VLAN interface on Switch is 1.1.1.1/24.

The NMS monitors the agent using SNMPv3. The agent reports errors or faults to the NMS.

Network diagram for SNMP configuration
a.
Configuration procedure
Table 42 Configure Agent
# Configuration IP addresses for the interfaces. (Procedure omitted)
# Enable SNMP.
 Select Device  SNMP from the navigation tree to enter the Setup page.
Description
Set UDP port number.
IMPORTANT:
The default port number is 162, which is the SNMP-specified port used for
receiving traps on the NMS. Generally (such as using iMC or MIB Browser as the
NMS), you can use the default port number. To change this parameter to another
value, you need to make sure that the configuration is the same with that on the
NMS.
Select the security model, that is, the SNMP version. Ensure that the SNMP
version is the same with that on the NMS; otherwise, the NMS cannot receive
any trap.
Set the authentication and privacy mode for SNMP traps when the security
model is selected as v3. The available security levels are: no authentication no
privacy, authentication but no privacy, and authentication and privacy.
When the security model is selected as v1 or v2c, the security level is no
authentication no privacy, and cannot be modified.
127
or SNMPv3 configuration task list.