When The Message "Please Change Imaging Unit." Appears; Changing The Imaging Unit - imagistics DF200 Operating Manual

10-16

4. When the Message "Please change Imaging Unit." Appears

Changing the Imaging Unit

1
Unlock Lock Release Lever [R1] and open
the Right Door.
CAUTION
NEVER touch the electrical contacts inside the
Right Door and underneath the Imaging Unit,
as an electrostatic discharge may damage the
machine.
When the life span of the Imaging Unit nears its
end, the message "Please change Imaging Unit."
appears on the Touch Panel. Change the Imaging
Unit as soon as possible once the message has
appeared.
Change the Imaging Unit following the procedure
given below.
4016P177CA
2
4015O114AA
3
Electrical Contacts
1166O264AB
NOTE
Do not throw away, but keep, the used Imaging
Unit, which will be collected by your Tech. Rep.
Holding the green hooks at the front and rear
of the Imaging Unit, carefully pull out the
old Imaging Unit. Then, holding the handle
on the top side of the Imaging Unit, take the
Imaging Unit out of the machine.
Shake well the new Imaging Unit
horizontally. Align the green labels on the
new Imaging Unit with those on the rails in
the machine and then slide the Imaging Unit
into the machine.
4015O115AB
1166U058AA
4015O116AB