Installing The Copier Installation Site; Power Source; Space Requirements - imagistics DF200 Operating Manual

1-2
1. Installing the Copier
Installation Site
To ensure utmost safety and prevent possible malfunctions of the copier, install it in a location which
meets the following requirements.
A place away from a curtain or the like that may catch fire and burn easily.
An area where there is no possibility of being splashed with water or other types of liquid.
An area free from direct sunlight.
A place out of the direct air stream of an air conditioner, heater, or ventilator.
A well-ventilated place.
A dry place.
A dust-free location.
An area not subject to undue vibration.
A stable and level location.
A place where ammonia or other organic gas is not generated.
A place which does not put the operator in the direct stream of exhaust from the copier.
A place which is not near any kind of heating device.

Power Source

The power source voltage requirements are as follows :
Use a power source with little voltage fluctuation.
Voltage Fluctuation
Frequency Fluctuation : Within ± 3Hz

Space Requirements

To ensure easy copier operation, supply replacements, and service maintenance, adhere to the
recommended space requirements detailed below. Allow a clearance of 12-1/4 inch or more at the back of
the copier for a ventilation duct and replacement of the toner bottle.
<With 9729, 9749, 9867, 9753 and 9752 mounted>
: Within ± 10% (127V : +6%, −10%)
65-3/4
41-3/4
4015O023AD
Unit: Inch