Lantronix MatchPort b/g Pro Command Reference Manual page 151

wpax
write
security (config-profile-security:default_adhoc_profile) level commands
advanced
apply wlan
basic
clrscrn
default key type
default suite
exit
key type hex
key type passphrase
no passphrase
passphrase <text>
show
show history
suite none
suite wep
suite wpa
suite wpa2
wep
wpax
write
serial (tunnel-serial:2) level commands
clrscrn
default dtr
dtr asserted while connected
dtr continuously asserted
dtr truport
dtr unasserted
exit
show
show history
write
serial (tunnel-serial:1) level commands
MatchPort® b/g Pro Embedded Device Server Command Reference
Enters the next lower level.
Stores the current configuration in permanent memory.
Switch to advanced level
Try out WLAN settings without saving them to Flash.
If the settings do not work, when you reboot the device,
it will still have the original settings.
Switch to basic level
Clears the screen.
Restores the key type to the default value (passphrase).
Restores the security method (suite) to the default value
(None).
Exit to the profiles level
Sets the key type to hex.
Sets the key type to passphrase.
Removes the passphrase.
Sets the passphrase. Maximum 63 characters.
<text> = put quotes around characters that make up the
passphrase.
Please refer to the other equipment's manual to determine
the passphrase
input style recommended.
NOTE: Lantronix recommends using a passphrase of 20
characters or more for
maximum security. Spaces and punctuation characters
are permitted.
Displays the current configuration.
Displays the last 20 commands entered during the current
CLI session.
Sets the security suite to None.
Sets the security suite to WEP.
Sets the security suite to WPA.
Sets the security suite to WPA2.
Enters the next lower level.
Enters the next lower level.
Stores the current configuration in permanent memory.
Clears the screen.
Restores default DTR control, asserted while connected.
Asserts DTR whenever a connect or accept mode tunnel
connection is active.
Asserts DTR regardless of any connections.
Asserts DTR to match remote DSR when connected via
Telnet.
Does not assert DTR.
Returns to the tunnel level.
Displays the current configuration.
Displays the last 20 commands entered during the current
CLI session.
Stores the current configuration in permanent memory.
5: Commands and Levels
151