Lantronix MatchPort b/g Pro Command Reference Manual page 141

clrscrn
exit
kill <line>
show <line>
show history
write
lpd 1 (config-lpd:1) level commands
banner disable
banner enable
binary disable
binary enable
capture disable
capture enable
clrscrn
convert newline disable
convert newline enable
eoj disable
eoj enable
eoj text binary <binary>
eoj text set <text>
exit
formfeed disable
formfeed enable
kill
line <line>
lpd <line>
no eoj text
MatchPort® b/g Pro Embedded Device Server Command Reference
Clears the screen.
Exits to the enable level.
Kills the current print job on the specified line.
<line> = LPD line with print job.
Displays lpd status for the specified line.
<line> = LPD line to display.
Displays the last 20 commands entered during the current
CLI session.
Stores the current configuration in permanent memory.
Disables printing banner for all print jobs. Only print the
banner when a
job requests it.
Enables printing banner for all print jobs.
Treats print job as ascii text. Filters out all non-ascii char-
acters and
certain control characters.
Treats print job as binary. Sends data byte-for-byte to the
printer.
Redirects serial output back to the line.
Redirects serial output from the line to this CLI session.
Clears the screen.
Disables converting single new line and carriage return
characters to
DOS-style line endings.
Enables converting single new line and carriage return
characters to
DOS-style line endings. If characters are already in DOS
line-ending order,
they are not converted.
Disables sending the end-of-job string after each print job.
Enables sending the end-of-job string after each print job.
Sets the end-of-job text allowing for binary characters.
<binary> = string in binary format that will be sent to the
printer at the
end of each print job.
Within [] use binary decimal up to 255 or hex up to 0xFF.
Sets the end-of-job text.
<text> = ascii string that will be sent to the printer at the
end of each
print job.
Exits to the configuration level.
Disables the printer from advancing to the next page at
the end of each
print job.
Forces the printer to advance to the next page at the end
of each print job.
Ends the current print job on this lpd line.
Enters the line level.
<line> = number of the line (serial port) to be configured.
Enters the configure lpd level.
<line> = number of the line (lpd serial port) to be config-
ured.
Removes the end-of-job string.
5: Commands and Levels
141