Lantronix MatchPort b/g Pro Command Reference Manual page 164

eap-ttls option mschap
eap-ttls option mschapv2
eap-ttls option pap
encryption ccmp disable
encryption ccmp enable
encryption tkip disable
encryption tkip enable
encryption wep disable
encryption wep enable
exit
ieee 802.1x eap-tls
ieee 802.1x eap-ttls
ieee 802.1x leap
ieee 802.1x peap
key <hexadecimal>
key text <text>
no key
no password
no username
password <text>
peap option eap-md5
peap option eap-mschapv2
show
show history
username <text>
validate certificate disable
validate certificate enable
write
wpax (config-profile-security-wpax:default_adhoc_profile) level commands
apply wlan
authentication 802.1x
authentication psk
MatchPort® b/g Pro Embedded Device Server Command Reference
Sets the EAP-TTLS authentication protocol option to
MSCHAP.
Sets the EAP-TTLS authentication protocol option to
MSCHAP V2.
Sets the EAP-TTLS authentication protocol option to PAP.
Disables this encryption method.
Enables this encryption method.
Disables this encryption method.
Enables this encryption method.
Disables this encryption method.
Enables this encryption method.
Exits to the next higher level.
Sets the IEEE 802.1x protocol to EAP-TLS.
Sets the IEEE 802.1x protocol to EAP-TTLS.
Sets the IEEE 802.1x protocol to LEAP.
Sets the IEEE 802.1x protocol to PEAP.
Sets key.
Each byte is represented by two adjacent hex digits.
Bytes may run together or be separated by optional punc-
tuation:
123ABC "12 3A BC" 12,3A,BC 12.3a.bc 12:3a:bc
Note that quotes must enclose the value if it contains
spaces.
Sets key.
Each byte is represented by a single character.
Note that quotes must enclose the value if it contains
spaces.
Removes key.
Clears the password.
Clears the user name.
Sets the value for the password.
<text> = put quotes around the characters (max 63).
Sets the PEAP authentication protocol option to EAP-
MD5.
Sets the PEAP authentication protocol option to EAP-
MSCHAP V2.
Shows the current configuration.
Displays the last 20 commands entered during the current
CLI session.
Sets the value of the username.
<text> = value in characters (max 63).
Skips verification of the server certificate when connect-
ing.
Requires verification of the server certificate when con-
necting.
Stores the current configuration in permanent memory.
Try out WLAN settings without saving them to Flash.
If the settings do not work, when you reboot the device,
it will still have the original settings.
Sets the authentication method to IEEE 802.1x.
Sets the authentication method to PSK.
5: Commands and Levels
164