Lantronix MatchPort b/g Pro Command Reference Manual page 144

additional port <number>
clrscrn
default response timeout
exit
kill connection <index>
no additional port
response timeout <milliseconds>
rss
show
show connections
show history
show statistics
tcp server state disable
tcp server state enable
write
modem (tunnel-modem:2) level commands
clrscrn
connect string <text>
default incoming connection
default response type
display remote ip disable
display remote ip enable
echo commands disable
echo commands enable
echo pluses disable
echo pluses enable
error unknown commands disable
error unknown commands enable
exit
incoming connection automatic
incoming connection disabled
incoming connection manual
no connect string
reassert
response type numeric
response type text
show
show history
show status
verbose response disable
MatchPort® b/g Pro Embedded Device Server Command Reference
Sets an additional TCP server port.
Clears the screen.
Restores the default Modbus Response Timeout.
Exits to the config level.
Kills modbus connection selected by index from show
connections.
Removes the additional TCP server port.
Sets the Modbus Response Timeout in milliseconds.
Enters the next lower level.
Displays the current configuration.
Displays connections.
Displays the last 20 commands entered during the current
CLI session.
Displays statistics.
Disables the Modbus TCP Server.
Enables the Modbus TCP Server.
Stores the current configuration in permanent memory.
Clears the screen.
Sets the CONNECT string used in modem emulation.
<string> = connect string.
Default disables incoming network connections.
Default uses text type responses.
The incoming RING has nothing following it.
The incoming RING is followed by the IP address of the
caller.
Does not echo modem commands.
Echoes modem commands.
Does not echo the +++ characters when entering modem
command mode.
Echoes the +++ characters when entering modem com-
mand mode.
Returns OK on unknown AT commands.
Returns an error upon unknown AT commands.
Returns to the tunnel level.
Automatically answer incoming network connections.
Disable incoming network connections.
Wait for an ATA command before answering an incoming
network connection.
Removes optional CONNECT string information for mo-
dem emulation.
Asserts tunnel modem status with current configured val-
ues.
Uses numeric type responses.
Uses text type responses.
Displays the current configuration.
Displays the last 20 commands entered during the current
CLI session.
Displays tunnel modem status.
Does not send Modem Response Codes.
5: Commands and Levels
144