Lantronix MatchPort b/g Pro Command Reference Manual page 130

show
show history
show status
state disable
state enable
write
if 2 (config-if:wlan0) level commands
bootp disable
bootp enable
clrscrn
default gateway <ip address>
default mtu
dhcp client id binary <binary>
dhcp client id set <text>
dhcp disable
dhcp enable
dhcp renew
domain <text>
exit
hostname <text>
if <instance>
ip address <ip address/cidr>
link
mtu <bytes>
no default gateway
no dhcp client id
no domain
no hostname
no ip address
no primary dns
no secondary dns
primary dns <ip address>
secondary dns <ip address>
show
show history
show status
state disable
state enable
write
MatchPort® b/g Pro Embedded Device Server Command Reference
Displays the current configuration.
Displays the last 20 commands entered during the current
CLI session.
Show interface status
Disables the interface.
Enables the interface.
Stores the current configuration in permanent memory.
Disables BOOTP.
Enables BOOTP.
Clears the screen.
Sets the configurable gateway IP address to the default
value.
Restores the default Maximum Transmission Unit (MTU)
size.
Sets the client id allowing binary characters.
Within [] use binary decimal up to 255 or hex up to 0xFF.
Sets the client id in text format.
Disables DHCP.
Enables DHCP.
Force DHCP to renew
Sets the domain name.
<text> = name of the domain.
Exits to the config level.
Sets the host name.
<text> = name of the host.
Changes to the interface configuration level.
Sets the IP address and network mask.
Formats accepted:
192.168.1.1 (default mask)
192.168.1.1/24 (CIDR)
"192.168.1.1 255.255.255.0" (explicit mask)
Enter link configuration level
Sets the Maximum Transmission Unit (MTU) size.
Clears the default gateway.
Clears the DHCP client ID.
Clears the domain name.
Clears the host name.
Clears the IP address.
Clears the name of the primary DNS server.
Clears the name of the secondary DNS server.
Sets the IP address of the primary DNS server.
Sets the IP address of the secondary DNS server.
Displays the current configuration.
Displays the last 20 commands entered during the current
CLI session.
Show interface status
Disables the interface.
Enables the interface.
Stores the current configuration in permanent memory.
5: Commands and Levels
130