Lantronix MatchPort b/g Pro Command Reference Manual page 159

write
tftp (config-tftp) level commands
allow file creation disable
allow file creation enable
allow firmware update disable
allow firmware update enable
allow xcr import disable
allow xcr import enable
clear counters
clrscrn
exit
no clear counters
show
show history
show statistics
state disable
state enable
write
traps (config-snmp-traps) level commands
clrscrn
exit
no primary destination
no secondary destination
primary destination <text>
secondary destination <text>
show
show history
state disable
state enable
write
tunnel 1 (tunnel:1) level commands
accept
auto show statistics
clear counters
clrscrn
connect
disconnect
exit
line <line>
lpd <line>
MatchPort® b/g Pro Embedded Device Server Command Reference
figured.
Stores the current configuration in permanent memory.
Prohibits the TFTP server from creating files on the file
system.
Enables the TFTP server to create files on the file system.
The TFTP server rejects any attempt to update firmware.
The TFTP server accepts a firmware image for update
based on the file name.
The TFTP server rejects any attempt to import XML con-
figuration.
The TFTP server accepts an XCR file for configuration
update based on the file name.
Sets the TFTP counters to zero.
Clears the screen.
Returns to the config level.
Restores the TFTP counters to the aggregate values.
Displays the current configuration.
Displays the last 20 commands entered during the current
CLI session.
Displays the TFTP statistics.
Disables the TFTP server.
Enables the TFTP server.
Stores the current configuration in permanent memory.
Clears the screen.
Exits to the next higher level.
Deletes the primary SNMP trap host.
Deletes the secondary SNMP trap host.
Sets the primary SNMP trap host.
<text> = IP address of host running the SNMP trap.
Sets the secondary SNMP trap host.
<text> = IP address of host running the SNMP trap.
Shows the current configuration.
Displays the last 20 commands entered during the current
CLI session.
Disables the sending of SNMP trap messages.
Enables the sending of SNMP trap messages.
Stores the current configuration in permanent memory.
Enters the accept level for this tunnel.
show connection statistics
Zeros all tunnel counters
Clears the screen.
Enters the connect level for this tunnel.
Enters the disconnect level for this tunnel.
Exits to the enable level.
Enters the line level.
<line> = number of the line (serial port) to be configured.
Enters the configure lpd level.
5: Commands and Levels
159