Lantronix MatchPort b/g Pro Command Reference Manual page 131

ip (config-ip) level commands
auto show statistics
clear counters
clrscrn
default ip time to live
default multicast time to live
exit
ip time to live <hops>
multicast time to live <hops>
no clear counters
show
show history
show statistics
write
ip filter (config-filter) level commands
add <ip address> <subnet mask>
clrscrn
exit
no filtering
remove <ip address> <subnet mask>
show
show history
write
key 1 (config-profile-security-wep-key:default_infrastructure_profile:1) level commands
apply wlan
clrscrn
exit
key <hexadecimal>
key text <text>
no key
show
show history
MatchPort® b/g Pro Embedded Device Server Command Reference
Continuously shows IP statistics
Zeros counters
Clears the screen.
Restores the default IP time to live.
Restores the default IP multicast time to live, which is one
hop.
Exits to the configuration level.
Sets the IP time to live, known by SNMP as
"ipDefaultTTL".
<hops> = number of hops that a typical IP packet is al-
lowed to live.
Sets the IP multicast time to live.
<hops> = number of hops that a multicast IP packet is
allowed to live.
Unzeros IP counters
Displays the current configuration.
Displays the last 20 commands entered during the current
CLI session.
Shows IP statistics
Stores the current configuration in permanent memory.
Adds an entry to the IP filter table.
Clears the screen.
Returns to the config level.
Removes filtering so ALL addresses are allowed.
Removes an entry from the IP filter table.
Displays the IP filter table.
Displays the last 20 commands entered during the current
CLI session.
Stores the current configuration in permanent memory.
Try out WLAN settings without saving them to Flash.
If the settings do not work, when you reboot the device,
it will still have the original settings.
Clears the screen.
Exits to the next higher level.
Sets key.
Each byte is represented by two adjacent hex digits.
Bytes may run together or be separated by optional punc-
tuation:
123ABC "12 3A BC" 12,3A,BC 12.3a.bc 12:3a:bc
Note that quotes must enclose the value if it contains
spaces.
Sets key.
Each byte is represented by a single character.
Note that quotes must enclose the value if it contains
spaces.
Removes key.
Shows the current configuration.
Displays the last 20 commands entered during the current
CLI session.
5: Commands and Levels
131