Lantronix MatchPort b/g Pro Command Reference Manual page 51

no email disconnect
no local port
no tcp keep alive
password
protocol ssh
protocol ssl
protocol tcp
protocol tcp aes
protocol telnet
show
show history
show status
start character <control>
tcp keep alive <milliseconds>
write
advanced (config-profile-advanced:default_infrastructure_profile) level commands
adhoc merging disable
adhoc merging enable
apply wlan
basic
clrscrn
default power management interval
default tx data rate
default tx data rate maximum
default tx power
default tx power maximum
default tx retries
exit
power management disable
power management enable
power management interval <beacons (100 ms each)>
MatchPort® b/g Pro Embedded Device Server Command Reference
accept mode tunnel.
Discontinues sending email alerts upon closing an accept
mode tunnel.
Uses the default port number as the local port for accept
mode tunneling.
The default port is 10000 + #, where # is the line number
for this tunnel.
Disables the accept mode TCP keep alive timeout.
Enters the next lower level.
Uses SSH protocol for accept mode tunneling.
Uses SSL protocol for accept mode tunneling.
Uses TCP protocol for accept mode tunneling.
Uses TCP protocol with AES encryption for accept mode
tunneling.
Uses Telnet protocol (with IAC) for accept mode tunnel-
ing.
Displays the current configuration.
Displays the last 20 commands entered during the current
CLI session.
Displays tunnel accept status.
Sets the accept mode start character.
The character may be input as text, control, decimal, or
hex.
A control character has the form <control>C.
A decimal value character has the form \99.
A hex value character has the form 0xFF.
Enables TCP keep alive for accept mode tunneling and
sets the timer.
<milliseconds> = timer value, in milliseconds.
Stores the current configuration in permanent memory.
Disables ad hoc merging.
Enables ad hoc merging.
Try out WLAN settings without saving them to Flash.
If the settings do not work, when you reboot the device,
it will still have the original settings.
Switch to basic level
Clears the screen.
Restores the power management interval to the default
value (1 beacon).
Restores the TX data rate to the default value (auto-
reduction).
Restores the maximum TX data rate to the default value
(54 Mbps).
Restores TX power to the default value (Fixed).
Restores the maximum TX power to the default value (14
dBm).
Restores TX retries to the default value (7).
Exit to the profiles level
Disables power management.
Enables power management.
Sets the power management time interval in beacons. (A
5: Commands and Levels
51