Mounting The Inverter On The Bracket; Figure 2-11 Proper Placement Of The Inverter On The Mounting Bracket - Xantrex GT2.5-NA Owner's Manual

Installation

Mounting the Inverter on the Bracket

Mounting a Single Inverter
Slide the mounting hooks on the inverter
over the hooks on the mounting bracket.
flange with
mounting slots

Figure 2-11 Proper Placement of the Inverter on the Mounting Bracket

2–22
http://www.wholesalesolar.com/inverters.html
To mount the inverter on the mounting bracket:
1. Place the GT Inverter's mounting hooks, located on the back of the enclosure,
over the bracket and ensure the inverter is seated properly, as shown in
Figure 2-11.
2. After the unit is correctly seated on the bracket hooks, locate the mounting
slots in the flange below the wiring box and mark the location on the wall for
securing screws.
3. Remove the inverter and drill pilot holes in the wallboard or siding for the
securing screws.
4. Reinstall the GT Inverter on the bracket and secure the bottom of the unit with
appropriate screws or anchors, and tighten.
110 cm (43")
Ground/floor
http://www.wholesalesolar.com/inverters.html
Bracket hooks
100 cm (39")
Ensure the inverter is seated
properly on the mounting bracket.
975-0245-01-01