Replacing the Wiring/Disconnect Box Cover
975-0245-01-01
http://www.wholesalesolar.com/inverters.html
After performing the voltage checks, replace all covers that were removed during
installation and startup.
WARNING: Shock hazard
Before reattaching covers, turn OFF the breaker switches in the main utility service panel
and the DC/AC Disconnect switch on the GT Inverter.
To replace the wiring/disconnect box cover:
1. Place the cover in position on the wiring box, being careful not to pinch any
wires inside.
2. Ensure that the two screw holes in the bottom of the wiring box cover are
aligned with the corresponding holes in the bottom of the wiring box.
3. Replace the two screws removed when the cover was removed (see
"Accessing the Wiring Terminals" on page 3–2), and tighten securely.
http://www.wholesalesolar.com/inverters.html
Replacing the Wiring/Disconnect Box Cover
4–3