Mounting the Inverter
Connecting the Chassis Ground
2–4
Do not mount the inverter under the hood of your vehicle. See
an Appropriate Location and Mounting Orientation" on page
To mount the inverter:
1. Make sure the On/Off switch is in the Off position.
2. Select an appropriate mounting location and orientation as
recommended in
Orientation" on page
3. Using the measurements found above in
page
1–7, mark the positions of the mounting screw holes in the
mounting surface where the inverter is to be permanently placed.
4. Pilot drill the four mounting screw holes.
5. Fasten the inverter to the mounting surface using corrosion-resistant
fasteners sized #10 or larger.
The inverter has a stud connector labelled
panel as shown in
Figure
the inverter to your vehicle chassis or system's DC grounding point as
required by regulations for some installations.
Do not use the DC ground lug for your AC grounding.
BATT.
NEG.
Chassis ground
Figure 2-1 Chassis Ground Location
This guide for use by qualified installers only.
"Choosing an Appropriate Location and Mounting
1–5.
2-1. This stud is used to connect the chassis of
1–5.
"Mounting Dimensions" on
on the side
CHASSIS GND
BATT.
POS.
975-0556-01-01
"Choosing