Figure 2-5 Mounting The Bracket For The Xw Inverter/Charger Or Distribution Panel - Xantrex XW4024-120/240-60 Installation Manual

2 × 4 wall stud
Wallboard
Plywood
(optional)
mounting plate
60" (152.4 cm) from floor
puts the inverter display
panel at approx. 65" high.
1
2
3
4
5

Figure 2-5 Mounting the Bracket for the XW Inverter/Charger or Distribution Panel

975-0239-01-01
Side View
Locate the wall studs.
If necessary, enhance the support surface with a ¾" plywood panel
secured to the wall studs. Plywood should span at least three wall
studs.
Use hardware sized to support a minimum of 500 lbs (not provided)
to secure the plywood to the wall.
Using a level, secure the first mounting bracket to the wall. Use
recommended anchoring hardware to secure the plate (see
Table 2-1).
Mount the next bracket adjacent to the first one. The brackets are
designed to interlock, so additional mounting brackets are easily
installed without additional measuring or levelling.
This manual for use by qualified personnel only
Step 1: Installing the Mounting Plate
Wall studs 16" on center behind wallboard
Multiple mounting plates should fit
together as shown.
Add ¾" plywood if additional
support is needed.
2–5