Monitoring The Front Panel Display; Figure 5-1 Front Panel Lcd Location - Xantrex GT2.5-NA Owner's Manual

Monitoring the Inverter

Monitoring the Front Panel Display

During startup
During waiting
period
During operation
When the inverter is
offline or there is
fault condition
Viewing more
information
5–2
http://www.wholesalesolar.com/inverters.html
During startup, the inverter's front panel LCD (see Figure 5-1) shows the first
three screens described in Table 5-1, "Startup Screens on GT Inverter Front Panel
Display" on page 5–3.
When the 305 second protection timer begins, the inverter displays "Reconnecting
in sss seconds" (see Table 5-10, "Special Message Screens" on page 5–9).
When the protection timer stops, the GT Inverter begins selling power, indicated
by the power output reading in the display (see Table 5-2, "Normal Operation
Default Screen" on page 5–4).
When the GT Inverter is offline (e.g., at night) or a fault condition has been
detected, the LCD shows a message screen to indicate that state. The specific fault
condition will be identified. See Table 5-5, "Offline Mode Default Display" on
page 5–5 and Table 5-8, "Fault Message Screens" on page 5–7.
Important:
The values in the front panel LCD are not user adjustable.
Grid Tie Solar Inverter
Front panel LCD

Figure 5-1 Front Panel LCD Location

Additional screens of information about the performance of the GT Inverter can be
displayed by tapping the Xantrex logo on the inverter front panel. This causes the
LCD to cycle through a series of information screens in Normal Operation,
Offline or Fault modes. These are described in detail in the following section,
"Front Panel Display Screens and What They Mean".
http://www.wholesalesolar.com/inverters.html
Tap Xantrex logo for backlight
and status screens
975-0245-01-01