Adjustable Disconnect Settings - Xantrex GT2.5-NA Owner's Manual

Adjustable Disconnect Settings

Setting
AC Low Voltage
AC High Voltage
AC High Reconnection
Voltage
AC Low Frequency
AC High Frequency
Reconnect Delay
975-0245-01-01
http://www.wholesalesolar.com/inverters.html
Islanding protection is an essential safety feature that ensures no person working
on the grid is harmed by a distributed energy source. Default software settings are
programmed into each GT Inverter at the factory to ensure it does not island
according to relevant safety regulations (UL1741, etc.).
In some instances it may be desirable from both a utility and customer point of
view to adjust these default settings. For example, the GT Inverter may experience
"nuisance trips" (taking the inverter "offline") if the grid is weak and the voltage
falls outside the allowable range specified in the regulations. It may be difficult
for a utility to upgrade the grid to eliminate this problem. With permission from
the utility, the factory settings may be changed to allow the GT inverter to operate
over a wider grid voltage range.
These settings are password protected and should only be changed by qualified
service personnel, using a special software application provided by Xantrex.
Changing any values may compromise compliance with safety regulations. Do
not do so without first consulting with the utility and agreeing on acceptable
settings.
The default values of these settings differ from the utility specifications on
page A–2. These differences take into account the accuracy ranges listed in the
table below, and are intended to ensure that utility specifications are always met.
Default Values
208 Vac/60 Hz 240 Vac/60 Hz
186 Vac 214 Vac
225 Vac 261 Vac
220.06 Vac 253.92 Vac
59.4 Hz
60.4 Hz
305 sec.
http://www.wholesalesolar.com/inverters.html
Adjustment Range Accuracy
± 5 Vac ± 3 Vac
± 5 Vac ± 3 Vac
± 1 Hz ± 0.1 Hz
65 to 305 sec. ± 5 sec.
Electrical Specifications
A–3