Figure 1-3 Wiring Box And Removable Inverter - Xantrex GT2.5-NA Owner's Manual

AC Disconnect
975-0245-01-01
http://www.wholesalesolar.com/inverters.html
wiring/disconnect box is an NEMA 3R enclosure to allow outdoor installation and
is clearly marked as a PV system disconnect. The lockable switch meets NEC
section 690 requirements as a means of disconnect.
In some jurisdictions, where the local utility requires that the AC disconnect be
capable of being locked in the open position by its service personnel, this
disconnect switch can also serve as a lockable and visible break isolating device.
Important:
In North America and other locations the wiring/disconnect box is an
electrical code requirement. It must be attached during operation. Check with your local
authorities before removing the GT Inverter wiring/disconnect box.
DC Connect
holes
Wiring/Disconnect Box
Front Cover
DC/AC Disconnect
Switch

Figure 1-3 Wiring Box and Removable Inverter

http://www.wholesalesolar.com/inverters.html
About the Xantrex Grid Tie Solar Inverter
Removable inverter (for
servicing, if required)
Control Board Connect hole
AC Connect hole
27 mm (1") threaded
conduit holes
1–5