Integral Liner Takeup Kit; Media Supply Hub; 3-Inch Adapter - Intermec EasyCoder PF4i User Manual

Chapter 7 — Options

Integral Liner Takeup Kit

Media Supply Hub

3-inch Adapter

70
Note: The cutter must be enabled during Configuration in Setup
Mode. For more information, see
"Paper Cutter" on page
The integral liner takeup unit is an optional device for peel-off
(self-strip) operation, which means the labels are separated from a
liner (backing paper) after printing and the liner is wound up on
an internal hub. The unit also includes a guide shaft. Peel-off
operation cannot be combined with Quick-Load guides.
This is a factory-installed option only and is used to separate
labels from the liner and wind up the spent liner inside the
printer's media compartment. Labels, tickets, tags, etc. can be
wound up inside the media compartment after printing by fitting
a special guide to the front of the print unit.
The kit consists of a stepper motor that drives the liner drive
roller in the print unit (fitted as standard) and a takeup hub in
the media compartment. A guide shaft is fitted to the center
section immediately behind the slack absorber. A guide plate is
fitted at the rear of the media compartment and can be used to
replace the standard tear bar on the print unit for batch takeup
operation.
Operation and media load are described in Chapter
Load" on page 17.
The rotating media supply hub is designed to fit media roll cores
with an internal diameter of 38-40 mm (1.5 inch). The hub can
be fitted in the same positions as the supply roll post, see Chapter
2. Being factory installed, the position of the media supply hub is
not intended to be changed by the operator.
The 3-inch/76 mm adapter is included in the package and makes
it possible to use media rolls with 3 inch/76 mm inner diameter
cardboard cores.
"Cutter" on page 50
69.
EasyCoder PF4i User's Guide (IPL Version)
and
3,"Media