Ethertalk; Preparations; Configuration Procedure - Xerox 4112 System Administration Manual

Xerox copier/printer system administration guide
Hide thumbs Also See for Xerox 4112:
Table of Contents

Advertisement

Configuration
Notes
The configuration can also be performed using IP configuration tools included in
CentreWare Internet Services or CentreWare Utilities. Refer to "Using CentreWare Internet
Services"
Enable the SOAP port and the SNMP port in most cases.
1. Enter the System Administrator Mode (Chapter 1 Entering the System Administrator mode
on page 1-10.)
2. Enable the IPP port.
a.
Select System Settings.
b.
Select Connectivity & Network Setup.
c.
Select Port Settings.
d.
Select IPP and then select Change Settings.
e.
Select Port Status and select Change Settings.
f.
Select Enable and then select Save.
3. If necessary, set the IP Address (Chapter 1 Setting the IP address on page 1-11).
4. Exit the System Administrator Mode (Chapter 1 Exiting the System Administrator mode on
page 1-11).
5. After the machine is restarted, print out the Printer Settings List to confirm that the IPP
port is enabled.
Note
Configure the IPP as necessary. Refer to IPP on page 3-14 for the IPP configuration.
Configuration on the computer
See Chapter 2 Configuration on the computer on page 2-2.

EtherTalk

Preparations

The following item is required when using an EtherTalk network:
A network environment where EtherTalk can be used.

Configuration procedure

Overview
The machine can be connected to computers using an EtherTalk network.
The following is the procedure to connect the machine to EtherTalk network:
Configuration on the Machine: Set up EtherTalk on the machine.
Configuration on the Computer: Install the print driver.
2-6
System Administration Guide
Xerox 4112/4127 Copier/Printer

Advertisement

Table of Contents
loading

This manual is also suitable for:

4127

Table of Contents