Xerox 4112 System Administration Manual page 91

3. Enable the SNMP port.
a. Select Network Settings.
b. Select Port Settings.
c. Select SNMP and then select Change Settings.
d. Select SNMP - Port and select Change Settings.
e. Select Enable and then select Save.
f. Select Close.
4. Enable the Internet service (HTTP) port as above.
5. Select Close.
6. If necessary, set the IP Address (Chapter 1 Setting the IP address on page 1-11).
7. Select Close repeatedly until the System Settings screen is displayed.
8. Exit the System Administrator Mode (Chapter 1 Exiting the System Administrator mode on
page 1-11).
9. After the machine is restarted, print out the Printer Settings List to confirm that the SOAP
port is enabled and the IP addresses are configured.
Using the Scan Service
Xerox 4112/4127 Copier/Printer
System Administration Guide
5-13