Using Centreware Internet Services; Preparations; Configuration Procedure - Xerox 4112 System Administration Manual

Using CentreWare
Internet Services

Preparations

Tip
The User Interface (UI) screens shown in this guide may or may not reflect the screens
displayed on your system. The UI screens vary from system to system and from marketplace to
marketplace. Therefore, the UI screens in this guide are a representation of the type of screens
that may be seen on your particular system.
The following items are needed to use CentreWare Internet Services:
• A computer which can use TCP/IP as the network protocol.
• The configuration of the machine which includes:
• IP address
• Subnet mask
• Gateway address
Note
Refer to Troubleshooting on page 10-1 when any troubles occur during the configuration.

Configuration procedure

CentreWare Internet Services provides a variety of services, including job and printer status, and
the ability to alter configurations using a web browser in a TCP/IP environment.
For setting as a printer, the properties screen of the services in CentreWare allow the users to
configure the system settings and port settings for each network that are otherwise set using
the touch screen on the machine.
Follow the procedure below to use CentreWare Internet Services.
• Configuration on the Machine: Configure the machine to be able to use CentreWare
Internet Services. First enable the Internet service port, then set the IP address.
• Confirmation of the Configuration: Confirm whether the machine is set to use CentreWare
Internet Services.
Xerox 4112/4127 Copier/Printer
System Administration Guide
3
3-1