Internet Printing Protocol (Ipp); Preparations; Configuration Procedure - Xerox 4112 System Administration Manual

f. Select Enable and then select Save.
3. If necessary, set the IP Address (Chapter 1 Setting the IP address on page 1-11).
4. Exit the System Administrator Mode (Chapter 1 Exiting the System Administrator mode on
page 1-11).
5. After the machine is restarted, print out the Printer Settings List to confirm that the SMB
port is enabled.
Note
If using the NetBEUI protocol, select NetBEUI as the protocol used by SMB for the port
configuration using CentreWare Internet Services.
Configure the SMB as necessary. Refer to Microsoft Networking (SMB) on page 3-6 for the SMB
configuration.
Configuration on the computer
See Chapter 2 Configuration on the computer on page 2-2.

Internet Printing Protocol (IPP)

Preparations

The following items are required when using Internet Printing Protocol (IPP):
• A network environment where TCP/IP can be used.
• The "CentreWare Utilities" CD-ROM, which is included with this product.

Configuration procedure

Overview
The machine can be connected to computers using IPP.
The following is the procedure to connect the machine to enable Internet Printing (IPP):
• Configuration on the Machine: Enable the IPP port on the machine
• Configuration on the Computer: Install the print driver
Configuration on the machine (IPP)
This section describes the configuration procedure to enable Internet Printing (IPP) on the
machine. First enable the IPP port, then set the IP address.
Configuration
Xerox 4112/4127 Copier/Printer
System Administration Guide
2-5