Xerox 4112 System Administration Manual page 22

Product Overview
4. Select Power Saver/Energy Saver, and select Change Settings.
5. Using the up/down arrow buttons, configure a power saver mode migration time from 1 to
240 minutes, in 1 minute increments.
a. From Last Selection to Low Power Mode: Set the time to move to the Low Power
Mode after the last operation.
Note
The default for From Last Selection to Low Power Mode is 15 minutes.
b. From Last Selection to Sleep Mode: Set the time to move to the Sleep Mode after
the last operation.
Notes
The default for From Last Selection to Sleep Mode is 60 minutes. Configure the From Last
Selection to Sleep Mode time to be longer than the From Last Selection to Low Power
Mode time.
6. Press Save.
7. Select Close.
8. Exit the System Administrator Mode (Chapter 1 Exiting the System Administrator mode on
page 1-11).
1-14 System Administration Guide
Xerox 4112/4127 Copier/Printer