Spanning Tree Configuration (Stp) Configuration; Stp Status; Gsm-2108/Gsm-1008Sfp - Waters Network Systems GSM2108 Operating Manual

5.19

Spanning Tree Configuration (STP) Configuration

The Spanning Tree Protocol (STP) is a standardized method (IEEE 802.1D) used to avoid loops
in switched networks. When STP is enabled, only one path is active between any two nodes on
the network at a time. Once Spanning Tree Protocol has been enabled, advanced functions can
be configured. It is recommend that STP is enabled to ensure a single active path on the
network.

5.19.1 STP Status

Function name:
STP Status
Function description:
Spanning Tree Status displays the current status of
described below:
Parameter description:
STP State:
Displays the current STP Enabled / Disabled status. Default is "Disabled".
Bridge ID:
Displays the switch's bridge ID which is the MAC address of this switch.
Bridge Priority:
Displays the switch's current bridge priority setting. Default is 32768.
Designated Root:
Displays the root bridge ID of this network segment. If this switch is a root bridge, the
"Designated Root" will show this switch's bridge ID.
Designated Priority:
Displays the current root bridge priority.
Root Port:
Waters Network Systems
Figure 5.44 – GVRP VLAN
User's Manual

GSM-2108/GSM-1008SFP

12 parameters. The 12 parameters are
Page 73