Rstp (Rapid Spanning Tree Protocol) Menu; Rstp Configuration - Waters Network Systems MS1008-2G-4POE Operating Manual

3. You can change the VLAN group name and VLAN ID.
4. Once you have made the changes, click apply to save the changes.
5.23

RSTP (Rapid Spanning Tree Protocol) Menu

RSTP is an evolution of the Spanning Tree Protocol and provides faster spanning tree
convergence once a topology change has been made. This switch supports both STP
and RSTP. The switch will auto detect the connected device that is running STP or
RSTP protocol.
5.23.1

RSTP Configuration

1. Spanning tree information about the Root Bridge can be viewed here.
2. Use this menu option to modify RSTP state. Remember to use the apply button to
save the configuration. The following lists information about spanning tree settings.
RSTP mode – RSTP must enabled before RSTP functions can be configured.
RSTP is disabled by default.
Priority (0-61440) - a value used to identify the root bridge. The bridge with the
lowest value has the highest priority and is selected as the root. If you change the
value, you must reboot the switch to assign the new path priority number. The
value must be multiple of 4096 according to the protocol standard rule.
Waters Network Systems
Figure 5.29 – Group Configuration Screen
MS1008-2G-4POE/PSX1008-2G-4PoE User's Manual Page 51