Network Applications; Using The Rs-232 Serial Port Connection - Waters Network Systems GSM2108 Operating Manual

4.0

Network Applications

There are three ways to access switch management functions:
1. RS-232 serial port connection (CLI)
2. Telnet
3. Web
Note: Before accessing management functions through Telnet or the Web, you must modify the
IP address, subnet mask, default gateway and DNS through the RS-232 connection.
4.1

Using the RS-232 Serial Port Connection

To configure the switch via the RS-232 serial port connection, follow these steps:
1. Connect the serial cable included with your switch to your workstation.
2. Connect the serial cable to console connector on the back of your switch.
3. Run the terminal emulator (Example: HyperTerminal) using the following settings.
a. Baud rate (bits per second):
b. Data bits:
c. Parity:
d. Stop bits:
e. Flow control:
4. When you complete the connection, press the Enter key.
5. Turn on the switch.
6. The default login is:
a. Username = admin
b. Password = admin
Waters Network Systems
Figure 3.7 - Attribute-based VLAN Diagram
57600
8
N
1
None
User's Manual
GSM-2108/GSM-1008SFP
Page 13