Waters Network Systems GSM2108 Operating Manual page 37

Displays the speed and duplex mode of all ports. There are three speeds 10Mbps, 100Mbps
and 1000Mbps supported for TP media. Duplex mode is half duplex and full duplex. If the
media is 1Gbps fiber, it is 1000Mbps only. The status of speed/duplex mode is determined by:
Negotiation of both the local port and the link partner in "Auto Speed" mode
User setting in "Force" mode. The local port has to be preset according to its capability.
Default: None, depends on the result of the negotiation.
Flow Control:
Show each port's flow control status.
There are two types of flow control in Ethernet, backpressure for half-duplex operation and
pause flow control (IEEE802.3x) for full-duplex operation. The switch supports both.
Default: Disabled
Parameter description of Port 7 and Port 8:
Connector Type:
Displays the connector type (UTP, SC, ST, LC, etc.)
Fiber Type:
Displays the fiber mode (multimode or singlemode).
Tx Central Wavelength:
Displays the fiber optical transmitting central wavelength, for instance, 850nm, 1310nm,
1550nm and so on.
Baud Rate:
Displays the maximum baud rate of the fiber module supported, for instance, 10M, 100M,
1G and so on.
Vendor OUI:
Displays the manufacturer's OUI code which is assigned by IEEE.
Vendor Name:
Displays the company name of the module manufacturer.
Vendor P/N:
Displays the product name by module manufacturer.
Vendor Rev (Revision):
Displays the module revision.
Vendor SN (Serial Number):
Displays the serial number assigned by the manufacturer.
Date Code:
Displays the date this SFP module was made.
Temperature:
Displays the current temperature of SFP module.
Waters Network Systems User's Manual
GSM-2108/GSM-1008SFP
Page 37