Configuring The Switch Via The Web - Waters Network Systems GSM2108 Operating Manual

Once you have set the IP address of the switch, you must save the configuration. The CLI
command is: save start.
A detailed list of CLI commands can be found in Section 6.0.
4.3

Configuring the Switch via the Web

You can configure and monitor the switch through:
CLI
Web browser
SNMP manager. The user interface for SNMP is not covered at this time.
Assign an IP address,
For example:
IP = 192.168.1.100
Subnet Mask = 255.255.255.0
Default Gateway = 192.168.1.254
Before you are able to communicate
the IP address of the switch. Once
these instructions:
1. Connect the switch with a UTP
Note: If the workstation connects
setup the same subnet mask
2. Access your web browser or use the console connection.
Note: If you make changes to the configuration, you must save the configuration before
rebooting the switch.
Waters Network Systems
Ethernet LAN
User's Manual
GSM-2108/GSM-1008SFP
Figure 4.2 – Front View
with the switch, you must know
you know the IP address, follow
cable to your workstations.
to the switch, you will have to
between them.
Page 15