Waters Network Systems GSM2108 Operating Manual page 106

Command Syntax
History history
Logout logout
Restore restore default
Default
Restore user restore user
Save Start save start
Save User save user
Waters Network Systems
Description
When you use help, all
commands are displayed. This
command will help you
distinguish between local and
global commands.
Displays the list of commands
you have been using during the
session. CLI supports up to
256 records. If no argument is
entered, CLI will list total
records up to 256. If an
argument is provided, CLI
would display the number of
records equal to the argument.
If you use this command via
Telnet connection, you will
logout and disconnect. If you
used this command through
direct console connection, you
will be logged out of the system
and return to the login prompt.
Use this command to restore
the startup configuration
provided by factory default. If
the restore is successful, you
will be prompted to reboot.
Once rebooted, startup
configuration will be reset to
factory default.
Restores startup configuration
as defined by user
configuration. If restoring is
successful, you will be
prompted to reboot. After
restoring the user defined
configuration, all changes in the
startup configuration would be
lost. After rebooting, the entire
startup configuration will
replace the user defined
configuration.
Use this command to save the
current configuration as the
startup configuration. This
command must be used in
order to use the current
configuration if the switch is
rebooted.
Use this command to save the
current configuration as the
user-defined configuration.
This command saves your
User's Manual
GSM-2108/GSM-1008SFP
Argument
Optional (Show last
number of history
records)
None
None
None
None
None
Page 106
Possible
Value
1, 2, 3....256
None
None
None
None
None