Configuring Ip, Subnet Mask And Default Gateway; Configuring The Switch Via The Web - Waters Network Systems ProSwitch 2800M Operating Manual

4.2

Configuring IP, Subnet Mask and Default Gateway

The default settings for your switch are listed in the following table:
You may either change the IP address of the switch or change the IP address of your
workstation. To change the IP address of the switch, via the console connection, you will have
to use the CLI command listed below. A complete list of CLI commands is in Section 6.0 of this
manual.
1. Once you have logged into the switch, you will see the following screen.
4.3

Configuring the Switch via the Web

You can configure and monitor the switch through:
 CLI
 Web browser
 SNMP manager. The user interface for SNMP is not covered at this time.
Assign an IP address,
For example:
IP = 192.168.1.100
Subnet Mask = 255.255.255.0
Default Gateway = 192.168.1.254
Waters Network Systems
Default Value
IP Address
192.168.1.1
Subnet
255.255.255.0
Default Gateway
192.168.1.254
Table 4-1
Figure 4.1 – Login screen
Figure 4.2 – Ethernet Port Connection
2800M/MR User's Manual
GSM2800M/MR
Ethernet LAN
Page 16