Configuring Common Settings For Vty User Interfaces (Optional) - HP 3100 v2 Series Configuration Manual

Step
11. Specify the command level of
the local user.
12. Specify Telnet service for the
local user.
13. Exit to system view.
14. Configure common settings for
VTY user interfaces.
The next time you attempt to Telnet to the CLI, you must provide the configured login username and
password, as shown in
provide the correct password to access the CLI. If the maximum number of login users has been
reached, your login attempt fails and the message "All user interfaces are used, please try later!"
appears.
Figure 11 Scheme authentication interface for Telnet login
Configuring common settings for VTY user interfaces
(optional)
You might be unable to access the CLI through a VTY user interface after configuring the
auto-execute command command on it. Before you configure the command and save the
configuration, make sure you can access the CLI through a different user interface.
To configure common settings for VTY user interfaces:
Step
1. Enter system view.
2. Enable copyright information
display.
3. Enter one or multiple VTY user
interface views.
4. Enable the terminal service.
Command
authorization-attribute level
level
service-type telnet
quit
See "Configuring common
settings for VTY user interfaces
(optional)."
Figure 11. If you are required to pass a second authentication, you must also
Command
system-view
copyright-info enable
user-interface vty
first-number [ last-number ]
shell
34
Remarks
Optional.
By default, the command level is
0.
By default, no service type is
specified.
N/A
Optional.
Remarks
N/A
By default, copyright information
display is enabled.
N/A
Optional.
By default, terminal service is
enabled.