Ike Signature-Identity From-Certificate - HP 6125XLG Command Reference Manual

Parameters
proposal-number: Specifies an IKE proposal number in the range of 1 to 65535. The lower the number,
the higher the priority of the IKE proposal.
Usage guidelines
During IKE negotiation:
• The initiator sends its IKE proposals to the peer.
If the initiator is using an IPsec with an IKE profile, the initiator sends all IKE proposals
referenced by the IKE profile to the peer. An IKE proposal specified earlier for the IKE profile has
a higher priority.
If the initiator is using an IPsec with no IKE profile, the initiator sends all its IKE proposals to the
peer. An IKE proposal with a smaller number has a higher priority.
The peer searches its own IKE proposals for a match. The search starts from the IKE proposal with
•
the highest priority and proceeds in the descending order of priority until a match is found. The
matching IKE proposals are used to establish the IKE SA. If all user-defined IKE proposals are found
mismatching, the two peers use their default IKE proposals to establish the IKE SA.
Examples
# Create IKE proposal 1 and enter its view.
<Sysname> system-view
[Sysname] ike proposal 1
[Sysname-ike-proposal-1]
Related commands
display ike proposal

ike signature-identity from-certificate

Use ike signature-identity from-certificate to configure the local device to always obtain the identity
information from the local certificate for signature authentication.
Use undo ike signature-identity from-certificate to restore the default.
Syntax
ike signature-identity from-certificate
undo ike signature-identity from-certificate
Default
The local end uses the identity information specified by local-identity or ike identity for signature
authentication.
Views
System view
Predefined user roles
network-admin
Usage guidelines
Configure the command on the local device that initiates aggressive IKE SA negotiations that use
signature authentication for compatibility with the peer device running a Comware V5-based release.
Such release supports only DN for signature authentication.
294