Reset Ipsec Sa - HP 6125XLG Command Reference Manual

# Change the IP address for the host test to 2.2.2.2.
[Sysname] ip host test 2.2.2.2
In this case, you must reconfigure the remote host name for the IPsec policy policy1 so that the local end
can obtain the latest IP address of the remote host.
# Reconfigure the remote host name to test for the IPsec tunnel in the IPsec policy policy1.
[Sysname] ipsec policy policy1 1 isakmp
[Sysname -ipsec-policy-isakmp-policy1-1] remote-address test
Examples
# Specify the remote IP address 10.1.1.2 for the IPsec tunnel.
<Sysname> system-view
[Sysname] ipsec policy policy1 10 manual
[Sysname-ipsec-policy-policy1-10] remote-address 10.1.1.2
Related commands
ip host (see Layer 3—IP Services Commands Reference)
•
• local-address

reset ipsec sa

Use reset ipsec sa to clear IPsec SAs.
Syntax
reset ipsec sa [ { ipv6-policy | policy } policy-name [ seq-number ] | profile policy-name | remote
{ ipv4-address | ipv6 ipv6-address } | spi { ipv4-address | ipv6 ipv6-address } { ah | esp } spi-num ]
Views
User view
Predefined user roles
network-admin
Parameters
{ ipv6-policy | policy } policy-name [ seq-number ]: Clears IPsec SAs for the specified IPsec policy.
ipv6-policy: Specifies an IPv6 IPsec policy.
•
policy: Specifies an IPv4 IPsec policy.
•
policy-name: Specifies the name of the IPsec policy, a case-sensitive string of 1 to 63 characters.
•
seq-number: Specifies the sequence number of an IPsec policy entry, in the range of 1 to 65535. If
•
no seq-number is specified, all the entries in the IPsec policy are specified.
profile profile-name: Clears IPsec SAs for the IPsec profile specified by its name, a case-sensitive string of
1 to 63 characters.
remote: Clears IPsec SAs for the specified remote address.
ipv4-address: Specifies a remote IPv4 address.
•
ipv6 ipv6-address: Specifies a remote IPv6 address.
•
spi { ipv4-address | ipv6 ipv6-address } { ah | esp } spi-num ]: Clears IPsec SAs for the specified SA triplet:
the remote address, the security protocol, and the SPI.
ipv4-address: Specifies a remote IPv4 address.
•
266