HP 6125XLG Command Reference Manual page 76

undo secondary accounting [ { ipv4-address | ipv6 ipv6-address } [ port-number | vpn-instance
vpn-instance-name ] * ]
Default
No secondary HWTACACS accounting server is specified.
Views
HWTACACS scheme view
Predefined user roles
network-admin
Parameters
ipv4-address: Specifies the IPv4 address of the secondary HWTACACS accounting server.
ipv6 ipv6-address: Specifies the IPv6 address of the secondary HWTACACS accounting server.
port-number: Specifies the service port number of the secondary HWTACACS accounting server, a TCP
port number in the range of 1 to 65535. The default setting is 49.
key { cipher | simple } string: Specifies the shared key for secure communication with the secondary
HWTACACS accounting server.
cipher string: Sets a ciphertext shared key. The string argument is case sensitive.
•
In non-FIPS mode, the key is a string of 1 to 373 characters.
In FIPS mode, the key is a string of 15 to 373 characters.
simple string: Sets a plaintext shared key. The string argument is case sensitive.
•
In non-FIPS mode, the key is a string of 1 to 255 characters.
In FIPS mode, the key is a string of 15 to 255 characters and must contain numbers, uppercase
letters, lowercase letters, and special characters.
vpn-instance vpn-instance-name: Specifies the MPLS L3VPN to which the secondary HWTACACS
accounting server belongs, where vpn-instance-name is a case-sensitive string of 1 to 31 characters. If
the server is on the public network, do not specify this option.
Usage guidelines
Make sure that the port number and shared key settings of the secondary HWTACACS accounting server
are the same as those configured on the server.
You can configure up to 16 secondary HWTACACS accounting servers for an HWTACACS scheme.
With the configuration, if the primary server fails, the device looks for a secondary server in active state
(a secondary HWTACACS accounting server configured earlier has a higher priority) and tries to
communicate with it.
If you use the undo secondary accounting command without specifying any parameter, the command
removes all secondary accounting servers.
Two accounting servers specified for a scheme, primary or secondary, cannot have identical IP address,
port number, and VPN settings.
If the specified server resides on an MPLS L3VPN, specify the VPN by using the vpn-instance
vpn-instance-name option. The VPN specified by this command takes precedence over the VPN specified
for the HWTACACS scheme.
You can remove an accounting server only when it is not used for user accounting. Removing an
accounting server affects only accounting processes that occur after the remove operation.
67