Service-Loopback-Group - HP 6125G Command Reference Manual

View
User view
Default level
2: System level
Parameters
number: Specifies the tunnel interface number.
Description
Use reset counters interface to clear the statistics of tunnel interfaces.
Before sampling network traffic within a specific period of time on an interface, you need to clear the
existing statistics.
If neither the tunnel keyword nor interface number is specified, this command clears the statistics of
•
all interfaces.
If only the tunnel keyword is specified, this command clears the statistics of all tunnel interfaces.
•
If both the tunnel keyword and interface number are specified, this command clears the statistics of
•
the specified tunnel interface.
Examples
# Clear the statistics of Tunnel 3.
<Sysname> reset counters interface tunnel 3

service-loopback-group

Syntax
service-loopback-group number
undo service-loopback-group
View
Tunnel interface view
Default level
2: System level
Parameters
number: Specifies the service loopback group ID.
Description
Use service-loopback-group to reference a service loopback group on the tunnel interface.
Use undo service-loopback-group to remove the referenced service loopback group from the tunnel
interface.
By default, no service loopback group is referenced on a tunnel interface.
The service loopback group to be referenced must have been configured and have the service type set
to tunnel in system view.
One tunnel interface can reference only one service loopback group.
Related commands: display interface tunnel; service-loopback group (Layer 2—LAN Switching
Command Reference).
164