Mtu; Reset Counters Interface - HP 6125G Command Reference Manual

Description
Use interface tunnel to create a tunnel interface and enter its view.
Use undo interface tunnel to delete a specific tunnel interface.
By default, no tunnel interface is created on the device.
Use the interface tunnel command to enter the interface view of a specific tunnel. If the specified tunnel
interface does not exist, the system will create the interface and enter its view.
A tunnel interface number is only locally significant. Thus, the tunnel interfaces on the two ends of a
tunnel can use the same or different interface numbers.
Related commands: display interface tunnel, display ipv6 interface tunnel, source, destination, and
tunnel-protocol.
Examples
# Create interface Tunnel 3 and enter its view.
<Sysname> system-view
[Sysname] interface tunnel 3
[Sysname-Tunnel3]

mtu

Syntax
mtu mtu-size
undo mtu
View
Tunnel interface view
Default level
2: System level
Parameters
mtu-size: Specifies the MTU on the tunnel interface, in the range of 100 to 64000 bytes.
Description
Use mtu to set the MTU on a tunnel interface.
Use undo mtu to restore the default.
By default, the MTU on a tunnel interface is 64000 bytes.
Examples
# Set the MTU for IPv4 packets on interface Tunnel 3 to 1432 bytes.
<Sysname> system-view
[Sysname] interface tunnel 3
[Sysname-Tunnel3] mtu 1432

reset counters interface

Syntax
reset counters interface [ tunnel [ number ] ]
163