Ipv6 Hoplimit-Expires Enable; Ipv6 Icmp-Error - HP 6125G Command Reference Manual

generated link-local address will not take effect and the link-local address of an interface is still the
manually assigned one. If you delete the manually assigned address, the automatically generated
link-local address is validated. For automatic generation of an IPv6 link-local address, see the ipv6
address auto link-local command.
Examples
# Configure a link-local address for VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] ipv6 address fe80::1 link-local

ipv6 hoplimit-expires enable

Syntax
ipv6 hoplimit-expires enable
undo ipv6 hoplimit-expires
View
System view
Default level
2: System level
Parameters
None
Description
Use ipv6 hoplimit-expires enable to enable the sending of ICMPv6 Time Exceeded packets.
Use undo ipv6 hoplimit-expires to disable the sending of ICMPv6 Time Exceeded packets.
By default, the sending of ICMPv6 Time Exceeded packets is enabled.
After you disable the sending of ICMPv6 Time Exceeded packets, the device will still send Fragment
Reassembly Time Exceeded packets.
Examples
# Disable the sending of ICMPv6 Time Exceeded packets.
<Sysname> system-view
[Sysname] undo ipv6 hoplimit-expires

ipv6 icmp-error

Syntax
ipv6 icmp-error { bucket bucket-size | ratelimit interval } *
undo ipv6 icmp-error
View
System view
Default level
2: System level
126