Arp Timer Aging; Display Arp - HP 6125G Command Reference Manual

A static ARP entry is effective when the device works normally. However, when the VLAN or VLAN
interface to which an ARP entry corresponds is deleted, the entry, if long, will be deleted, and if short and
resolved, will become unresolved.
The vlan-id argument specifies the VLAN corresponding to an ARP entry and must be the ID of an existing
VLAN. In addition, the Ethernet interface following the argument must belong to that VLAN. The VLAN
interface of the VLAN must have been created.
If both the vlan-id and ip-address arguments are specified, the IP address of the VLAN interface
corresponding to the vlan-id argument must be in the same network segment as the IP address specified
by the ip-address argument.
Related commands: reset arp and display arp.
Examples
# Configure a static ARP entry, with IP address 202.38.10.2, MAC address 00e0-fc01-0000, and
outbound interface GigabitEthernet 1/0/1 of VLAN 10.
<Sysname> system-view
[Sysname] arp static 202.38.10.2 00e0-fc01-0000 10 GigabitEthernet 1/0/1

arp timer aging

Syntax
arp timer aging aging-time
undo arp timer aging
View
System view
Default level
2: System level
Parameters
aging-time: Specifies the age timer for dynamic ARP entries in minutes, ranging from 1 to 1440.
Description
Use arp timer aging to set the age timer for dynamic ARP entries.
Use undo arp timer aging to restore the default.
By default, the age timer for dynamic ARP entries is 20 minutes.
Related commands: display arp timer aging.
Examples
# Set the age timer for dynamic ARP entries to 10 minutes.
<Sysname> system-view
[Sysname] arp timer aging 10

display arp

Syntax
display arp [ [ all | dynamic | static ] [ slot slot-number ] | vlan vlan-id | interface interface-type
interface-number ] [ count | verbose ] [ | { begin | exclude | include } regular-expression ]
3