Ipv6 Address; Ipv6 Address Anycast - HP 6125G Command Reference Manual

By default, IPv6 is disabled.
Examples
# Enable IPv6.
<Sysname> system-view
[Sysname] ipv6

ipv6 address

Syntax
ipv6 address { ipv6-address prefix-length | ipv6-address/prefix-length }
undo ipv6 address [ ipv6-address prefix-length | ipv6-address/prefix-length ]
View
Interface view
Default level
2: System level
Parameters
ipv6-address: Specifies the IPv6 address.
prefix-length: Specifies the prefix length of the IPv6 address, in the range of 1 to 128.
Description
Use ipv6 address to configure an IPv6 global unicast address for an interface.
Use undo ipv6 address to remove the IPv6 address from the interface.
By default, no global unicast address is configured for an interface.
Except for the link-local address automatically obtained and the link-local address generated through
stateless autoconfiguration, all IPv6 addresses will be removed from the interface if the undo ipv6
address command is executed without any parameter specified.
Examples
# Set the global IPv6 unicast address of VLAN-interface 100 to 2001::1 with prefix length 64.
Method 1:
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] ipv6 address 2001::1/64
Method 2:
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] ipv6 address 2001::1 64

ipv6 address anycast

Syntax
ipv6 address ipv6-address/prefix-length anycast
undo ipv6 address ipv6-address/prefix-length anycast
122