Shutdown; Source - HP 6125G Command Reference Manual

Examples
# Create service loopback group 1 of tunnel type.
<Sysname> system-view
[Sysname] service-loopback group 1 type tunnel
# Add a Layer 2 Ethernet port to service loopback group 1.
[Sysname] interface GigabitEthernet 1/0/1
[Sysname-GigabitEthernet1/0/1] undo stp enable
[Sysname-GigabitEthernet1/0/1] undo lldp enable
[Sysname-GigabitEthernet1/0/1] port service-loopback group 1
[Sysname-GigabitEthernet1/0/1] quit
# Reference service loopback group 1 on interface Tunnel 2.
[Sysname] interface tunnel 2
[Sysname-Tunnel2] service-loopback-group 1

shutdown

Syntax
shutdown
undo shutdown
View
Tunnel interface view
Default level
2: System level
Parameters
None
Description
Use shutdown to shut down a tunnel interface.
Use undo shutdown to bring up a tunnel interface.
By default, a tunnel interface is in the up state.
Examples
# Shut down interface Tunnel 1.
<Sysname> system-view
[Sysname] interface tunnel 1
[Sysname-Tunnel1] shutdown

source

Syntax
source { ip-address | ipv6-address | interface-type interface-number }
undo source
View
Tunnel interface view
165