Destination - HP 6125G Command Reference Manual

Parameters
text: Description of an interface, a string of 1 to 80 characters.
Description
Use description to configure a description for the current interface.
Use undo description to restore the default.
By default, the description of a tunnel interface is Tunnelnumber Interface, for example, Tunnel1
Interface.
Related commands: display interface tunnel.
Examples
# Configure the description of interface Tunnel 1 as tunnel1.
<Sysname> system-view
[Sysname] interface tunnel 1
[Sysname-Tunnel1] description tunnel1

destination

Syntax
destination { ip-address | ipv6-address }
undo destination
View
Tunnel interface view
Default level
2: System level
Parameters
ip-address: Specifies the tunnel destination IPv4 address.
ipv6-address: Specifies the tunnel destination IPv6 address.
Description
Use destination to specify the destination address for the tunnel interface.
Use undo destination to remove the configured tunnel destination address.
By default, no tunnel destination address is configured.
The tunnel destination address must be a public address.
The tunnel destination address is the address of the peer interface receiving packets and should be
configured as the source address of the peer tunnel interface.
Automatic tunnel interfaces using the same encapsulation protocol must have different source addresses.
Manual tunnel interfaces using the same encapsulation protocol must have different source and
destination addresses.
Related commands: source, interface tunnel, display interface tunnel, and display ipv6 interface tunnel.
Examples
# Configure interface VLAN-interface 100 (193.101.1.1) of Sysname 1 and interface VLAN-interface 100
(192.100.1.1) of Sysname 2 as the source and destination interfaces of a tunnel between the two devices.
154