HP 6125G Command Reference Manual page 164

Field
Tunnel protocol/transport
Last clearing of counters
Last 300 seconds input: 0 bytes/sec,
0 packets/sec
Last 300 seconds output: 0
bytes/sec, 0 packets/sec
packets input
input error
packets output
output error
# Display brief information about interface Tunnel 0.
<Sysname> display interface tunnel 0 brief
The brief information of interface(s) under route mode:
Link: ADM - administratively down; Stby - standby
Protocol: (s) - spoofing
Interface
Tun0
# Display brief information about interface Tunnel 1 in the DOWN state.
<Sysname> display interface tunnel brief down
The brief information of interface(s) under route mode:
Link: ADM - administratively down; Stby - standby
Interface
Tun1
Table 39 Command output
Field
The brief information of
interface(s) under route mode
Link: ADM - administratively
down; Stby - standby
Protocol: (s) - spoofing
Interface
Description
Tunnel mode and transport protocol:
•
IP/IP—IPv4 over IPv4 tunnel mode.
•
IP/IPv6—IPv4 over IPv6 tunnel mode.
•
IPv6/IP—IPv6 over IPv4 manual tunnel mode.
•
IPv6/IP 6to4—IPv6 over IPv4 6to4 tunnel mode.
•
IPv6/IP ISATAP—IPv6 over IPv4 ISATAP tunnel mode.
•
IPv6/IPv6—IPv6 over IPv6 tunnel mode.
Last time of clearing of counters.
Average input rate in the last 300 seconds in bytes/sec or
packets/sec.
Average output rate in the last 300 seconds in bytes/sec or
packets/sec.
Total number of input packets.
Number of input error packets.
Total number of output packets.
Number of output error packets.
Link Protocol Main IP
UP UP 1.1.1.1
Link Cause
DOWN Not connected
Description
Brief information about Layer 3 interfaces.
Link status. If the interface has been administratively shut down, ADM is
displayed. To recover its physical state, perform the undo shutdown
command.
(s) indicates that the network layer protocol state is UP, but the link is not
available because it is an on-demand link or not present at all.
Abbreviated interface name.
157
Description