Tunnel Discard Ipv4-Compatible-Packet; Tunnel-Protocol - HP 6125G Command Reference Manual

Description
Use tunnel bandwidth to set the bandwidth of the tunnel interface.
Use undo tunnel bandwidth to restore the default.
By default, the bandwidth of the tunnel interface is 64 kbps.
The tunnel interface bandwidth set with the tunnel bandwidth command is for dynamical routing
protocols to calculate the cost of a tunnel path, rather than changes the bandwidth of the tunnel interface.
Refer to the bandwidth of the output interface of the packet when you set the bandwidth of the tunnel
interface.
Examples
# Configure the bandwidth of Tunnel 0 as 100 kbps.
<Sysname> system-view
[Sysname] interface tunnel 0
[Sysname-Tunnel0] tunnel bandwidth 100

tunnel discard ipv4-compatible-packet

Syntax
tunnel discard ipv4-compatible-packet
undo tunnel discard ipv4-compatible-packet
View
System view
Default level
2: System level
Parameters
None
Description
Use tunnel discard ipv4-compatible-packet to enable dropping of IPv6 packets using IPv4-compatible
IPv6 addresses.
Use undo tunnel discard ipv4-compatible-packet to restore the default.
By default, IPv6 packets using IPv4-compatible IPv6 addresses are not dropped.
The tunnel discard ipv4-compatible-packet command enables the device to check the source and
destination IPv6 addresses of the de-encapsulated IPv6 packets from the tunnel and discard packets that
use a source or destination IPv4-compatible IPv6 address.
Examples
# Enable dropping of IPv6 packets using IPv4-compatible IPv6 addresses.
<Sysname> system-view
[Sysname] tunnel discard ipv4-compatible-packet

tunnel-protocol

Syntax
tunnel-protocol { ipv4-ipv4 | ipv4-ipv6 | ipv6-ipv4 [ 6to4 | isatap ] | ipv6-ipv6 }
167