Configuring Jumbo Frame Operation; Overview - HP ProCurve 6120G/XG Configuration Manual

Port Traffic Controls
Jumbo Frames

Configuring Jumbo Frame Operation

Command
show vlans
show vlans ports < port-list > 12-24
show vlans < vid >
jumbo
jumbo max-frame-size

Overview

1. Determine the VLAN membership of the ports or trunks through which
2. Ensure that the ports through which you want the switch to receive jumbo
3. Use the jumbo command to enable jumbo frames on one or more VLANs
4. Execute write memory to save your configuration changes to the startup­
12-22
Page
12-23
12-25
12-25
12-25
you want the switch to accept inbound jumbo traffic. For operation with
GVRP enabled, refer to the GVRP topic under "Operating Rules", above.
frames are operating at least at gigabit speed. (Check the Mode field in the
output for the show interfaces brief < port-list > command.)
statically configured in the switch. (All ports belonging to a jumbo-
enabled VLAN can receive jumbo frames.
config file.