Intermec WA21 System Manual page 91

MobileLAN access WA2X System Manual
End devices that perform passive scanning do not support a mixed security
environment. In passive scanning, an end device listens for beacons (sent
by the access point radio's primary service set), picks one it likes, and then
associates with it. The beacons contain a security bit that advertises the
type of security the primary service set is using. If the end device's security
setting does not match the beacon's security bit, the end device cannot
associate.
For details, see "When You Configure Different SSIDs With Different
Security Settings" on page 136.
To configure the 802.11g radio
1 From the main menu, click 802.11g Radio. The 802.11g Radio screen
appears.
2 Configure the parameters for the radio. For help, see the next table.
3 Configure the advanced parameters for the radio. For help, see
"Configuring 802.11g Radio Advanced Parameters" on page 80.
4 (Master only) Configure inbound filters. For help, see "Configuring
802.11g Radio Inbound Filters" on page 83.
5 Click Submit Changes to save your changes. To activate your changes,
from the menu bar click Save/Discard Changes, and then click Save
Changes and Reboot. For help, see "Saving Configuration Changes"
on page 33.
6 (Optional) Configure security by clicking Configure security settings
for this service set. For help, see Chapter 6, "Configuring Security."
Chapter 4 — Configuring the Radios
77