Intermec WA21 System Manual page 42

Chapter 1 — Getting Started
28
To use a communications program
1 Use the RS-232 null-modem cable to connect the serial port on the
access point to a serial port on your PC. You may need to remove the
serial port plug.
2 Start the communications program and configure the serial port
communications parameters on your PC, and then click OK. You
should configure the serial port communications parameters to:
Bits per second 9600
Data bits 8
Parity None
Stop bit 1
Flow control None
3 Connect the access point to power. The access point has no On/Off
switch, so it boots as soon as you apply power.
4 Press Enter when the message "
PC screen. The Username field appears.
5 In the Username field type the default user name
press Enter. The user name is case sensitive.
6 In the Password field type the default password
press Enter. The password is case sensitive. The Access Point
Configuration menu appears.
" appears on your
Starting system
Intermec
Intermec
MobileLAN access WA2X System Manual
, and then
, and then