Intermec WA21 System Manual page 70

Chapter 3 — Configuring the Ethernet Network
56
6 Configure the DHCP server. For help, see the next table.
7 Click Submit Changes to save your changes. To activate your changes,
from the menu bar click Save/Discard Changes, and then click Save
Changes and Reboot. For help, see "Saving Configuration Changes"
on page 33.
DHCP Server Setup Parameter Descriptions
Parameter Explanation
Low Address Enter the low IP address in the range of IP addresses available to the
DHCP server for distribution to DHCP clients.
If these addresses are not on the same subnet as the access point, the
access point will perform Network Address Translation (NAT) for
the clients to which it grants IP addresses.
High Address Enter the high IP address in the range of IP addresses available to
the DHCP server for distribution to DHCP clients.
If these addresses are not on the same subnet as the access point, the
access point will perform Network Address Translation (NAT) for
the clients to which it grants IP addresses.
Lease Time Specifies the duration of the leases that are granted by the DHCP
server. Enter the lease time in the format days:hours:minutes.
If you set the lease time to 0, infinite leases are granted.
Permanently If you check this check box, the DHCP server stores permanent
Save IP Address mappings of IP addresses to DHCP client identifiers. A DHCP
Mappings
client is guaranteed to receive the same IP address each time it
requests an address even if the DHCP server reboots.
If you clear this check box, the DHCP server tries to grant clients
the same address each time, but that result is not guaranteed.
MobileLAN access WA2X System Manual