Intermec WA21 System Manual page 231

MobileLAN access WA2X System Manual
To configure the TGAP
1 From the main menu, click Telnet Gateway. The Telnet Gateway
screen appears.
2 Configure the parameters for up to eight TCP/IP hosts. For help, see
the next table.
3 Click Submit Changes to save your changes. To activate your changes,
from the menu bar click Save/Discard Changes, and then click Save
Changes and Reboot. For help, see "Saving Configuration Changes"
on page 33.
Telnet Gateway Screen Parameters
Parameter Description
Host Name Enter the IP address or the DNS name of the host.
Host Port Enter the TCP port number that the gateway uses to connect to the
host server. This port is usually 23, unless the host has been specially
configured.
Term Port Enter the TCP port number that the TE 2000 client uses to connect
to the gateway. Communications between the client and the gateway
occur on the Term Port. If this port is on, it is usually set to 23,
unless the client has been specially configured.
Off: The Term Port is disabled (default).
23: The TCP port reserved by the IANA for telnet servers. The
client will be able to connect normally.
5000 to 5009: Optional TCP ports to which a specially-configured
client may connect.
Chapter 9 — Additional Access Point Features
217