Intermec WA21 System Manual page 120

Chapter 5 — Configuring the Spanning Tree
106
2 Configure the spanning tree parameters. For help, see the next table.
3 Click Submit Changes to save your changes. To activate your changes,
from the menu bar click Save/Discard Changes, and then click Save
Changes and Reboot. For help, see "Saving Configuration Changes"
on page 33.
4 (Optional) Configure security by clicking Configure Spanning Tree
Security. For help, see "Creating a Secure Spanning Tree" on page 143.
Spanning Tree Parameter Descriptions
Parameter Explanation
AP Name Enter a unique name for this access point. The name can be
from 1 to 16 characters. The default is the access point serial
number.
LAN ID (Domain) Enter the LAN ID. All access points must have the same LAN
ID to participate in the same spanning tree. The LAN ID is a
number from 0 to 254.
Root Priority Determines if this access point is a candidate to become the root
of the spanning tree. The access point with the highest root
priority becomes the root whenever it is powered on and active.
The root priority can be a value from 0 to 7.
If you set the root priority to 0, the access point can never
become the root access point. All access points on the secondary
LAN should have a root priority of 0.
For help deciding if this access point should be a candidate to
become root, see the selection criteria listed on page 101.
MobileLAN access WA2X System Manual